KAVB2064-E
Error in writing execution results to Command execution log.
An attempt to write the command execution log file has failed.
- (S)
-
Does not save the command execution results in the command execution log file.
- (O)
-
Check the following. If the problem cannot be corrected, use the data collection tool to collect data, and then contact the system administrator.
-
Make sure that there are sufficient system resources.
-
Make sure that the operating system is running normally.
-
Make sure that the disk to which the command execution log file is output has sufficient free space.
-
Make sure that the output destination of the command execution log file has appropriate permissions.
-
The command execution log file might be corrupted. In this case, execute either of the following commands to recover the execution log file:
For details on how to check the status of the command execution log file and how to recover the file, see the chapter about troubleshooting in the JP1/Integrated Management 3 - Manager Administration Guide.
If the command execution log file is in normal status, execute the data collection tool of JP1/IM, and then contact the system administrator.
-