4.6 Setting Hitachi Network Objectplaza Trace Library (HNTRLib2)
JP1/Base outputs log files using the Hitachi Network Objectplaza Trace Library (HNTRLib2). These log files trace the system processing invoked in JP1/Base and in program products for which JP1/Base is a pre-requisite program. The logged data can be used for investigating the cause of any errors that might occur in a JP1 program.
The default settings are as follows:
-
Size of one log file:256 KB
-
Maximum number of log files: 4
-
Output directory:
- In Windows
-
system-drive\Program Files (x86)\Hitachi\HNTRLib2\spool\hntr2*.log
system-drive\Program Files\Hitachi\HNTRLib2\spool\hntr2*.log
- In UNIX:
-
/var/opt/hitachi/HNTRLib2/spool/hntr2*.log
Although there is usually no need to change these settings, you can view and change the default settings by executing the hntr2utl2, hntr2conf, or hntr2getconf command. For details on the commands, see hntr2utl2 (Windows only), hntr2utl2 (UNIX only), hntr2conf, hntr2getconf in 15. Commands.
A message might be broken if the integrated trace log data is output from multiple processes at the same time. Therefore, enable the exclusive integrated trace log function to monitor a specific message by using the log file trap definition file. For details on exclusive functions, see hntr2conf in 15. Commands.