3.3.3 Uninstalling JP1/Base

To uninstall JP1/Base:

1. Quit all programs.

   Be sure to quit all JP1 programs. Also, quit all programs that are currently accessing the event service.

   If you are using JP1/AJS - Manager, stop the JP1/AJS - Monitor service.

2. Run the Hitachi Program Product Installer.

   Uninstall JP1/Base as prompted by the Hitachi Program Product Installer. All user files in the JP1/Base installation directory will be deleted at uninstallation. Therefore, be sure to back up required files first.

   If a product that requires JP1/Base is installed, Deletion failed. is displayed, and uninstallation fails. In this case, check that the KAVA1870-E message has been output to the following JP1/Base installation log (latest log file):

   /tmp/HITACHI_JP1_INST_LOG/jp1base_inst{1|2|3|4|5}.log

   After uninstalling the applicable JP1 product, uninstall JP1/Base following the instructions of Hitachi Program Product Installer.

Note

Uninstalling JP1/Base causes HNTRLib2 to be uninstalled automatically. If the system contains other programs that use HNTRLib2, however, HNTRLib2 is not uninstalled until all of those programs are uninstalled.

To Page Top