3.2 Installing and setting up the logical host
This section describes installation and setup of the logical host for JP1/IM - EG for NNMi.
JP1/IM - EG for NNMi must run on the same logical host where NNMi and JP1/Base run.
Before you start the procedure, check the cluster system information shown in the table below.
Item to be checked |
Description |
---|---|
Logical host name |
Name of the logical host that executes the services of JP1/Base and NNMi |
Logical IP address |
IP address that corresponds to the logical host name |
Shared folder (or shared directory) |
Folder (or directory) on the shared disk that stores the file set for the JP1 execution environment on the logical host |
For details about the prerequisites and the supported scope of cluster operation, see the JP1/Base User's Guide.
After you have finished checking these items, you can start installation and setup.
- Important
-
-
In Windows, install both the active server and the standby server on the same drive and in the same folders. Do not install the logical host on the shared disk.
-
Before you set up JP1/IM - EG for NNMi in a cluster system, make sure that JP1/IM - EG for NNMi on the physical host has terminated. If you set up the cluster system while JP1/IM - EG for NNMi is running on the physical host, the logical host services will no longer function correctly. In such a case, you must restart the server to recover the system.
-