KAVB3107-E
Cannot set configuration in the host. host-name
Configuration information could not be set in certain hosts during configuration definition confirmation.
- S:
-
Places the jbsrt_distrib command in error status.
- O:
-
On the host that has the error, check the following items:
-
Is JP1/Base running? (Can be checked with the jbs_spmd_status command.)
-
Is the configuration management port (initialized to 20237/tcp) running? (Can be checked with the netstat command.)
-
Is the configuration management port (initialized to 20237/tcp) being filtered by a firewall or similar utility?
-
Is it possible to resolve the name of the host that has the error from a higher-level host than the host that has the error? (Can be checked with the jp1ping command.)
-
Is the IP address found by resolving the name of the intended IP address?
-
Was the host that has the error previously defined as the highest-level host? (Can be checked with the jbsrt_get command.) If the configuration definition information from when it was the highest-level host remains, execute the jbsrt_del command to delete the configuration information.
-
Has a memory shortage occurred?
-
Are there write and read permissions for the conf/route/ directory?
If the problem is other than the above, check the following items in the host that has the error:
-
Execute the jbsrt_get command.
-
Determine whether any of the following have occurred:
• Was a KAVB3162-E message output?
• Did the jbsrt_get command end abnormally?
• Is the local host name displayed as a higher-level host or a lower-level host?
• Is a host name other than the local host name displayed as the local host?
• Is the host name misspelled?
-
If any of the above occurred, use the following method to recover from the error:
1. Execute the jbsrt_del command to delete the configuration definition information.
2. On the manager host, execute the jbsrt_distrib command to redistribute the configuration definition information.
-