8.1.4 Checking command execution status and deleting a command
After a command is executed from the Execute Command window of JP1/IM - View, if the message reporting execution termination (KAVB2013-I) is not displayed in Log, a problem may have occurred at the command execution host.
In this case, follow the procedure described below to check the command execution status, and if necessary, delete the command.
- Important
-
The procedure described here can be used only when the version of JP1/Base on the command execution host is 07-51 or later. This procedure cannot be used if the JP1/Base version is 07-00 or earlier.
To check the command execution status and delete a command:
-
Using the jcocmdshow command, check the command status.
Execute the jcocmdshow command on the command execution host, and based on the returned information, investigate whether a problem has occurred. Based on the investigation, if it is determined that the command needs to be stopped, proceed to the next step.
-
Using the jcocmddel command, delete the command.
Execute the jcocmddel command on the command execution host to delete the command.
-
Using the jcocmdshow command, check the command status.
Execute the jcocmdshow command to determine whether the command has been correctly deleted.
- For the command syntax:
-
See the chapter that explains commands in the JP1/Base User's Guide.