7.3.6 Newly installing JP1/IM - Agent with integrated agent host (for Windows)

Install the JP1/IM - Agent on the local disk of the primary server and the secondary server.

1. Newly installing JP1/IM - Agent.

   For details on how to install the software, see 1.3.1(3) Procedure of JP1/IM - Agent installation.

   Select "Normal installation mode" for the installation mode.

   This command is executed for both the primary server and the secondary server.

   In the case of Windows, the installation destination folder must be the same path on the executable server and the standby server.

   Do not start the JP1/IM - Agent service on the physical host. If it is running, stop it.

2. Create a configuration file for the new setup command for the logical host.

   For details about configuration file, see Configuration file of the logical host new setup (any-file-name) in Chapter 2. Definition Files in the JP1/Integrated Management 3 - Manager Command, Definition File and API Reference.

   In addition, configuration file's sample filename is stored in the following path: You can copy and create.

   JP1/IM-Agent-Installation-destination-folder\jp1ima\conf\sample\jpc_lhsetup.properties

3. Run a new setup command for the logical host.

   jimalhsetup -h logical-hostname -d shared-folder -c {online|standby}-f setup-configuration-file [-q]

   For details about the new setup command for logical hosts, see jimalhsetup in Chapter 1. Commands in the JP1/Integrated Management 3 - Manager Command, Definition File and API Reference.

   This command is executed on both the running server and the standby server.

4. Verify that Windows has registered to servicing.

   On both the primary server and the secondary server, display the service of Windows to confirm that the service for logical host has been registered.

   The name of the service for the logical host is the name appended with _logical-host-name.

5. Configure TLS settings.

   When operating with TLS enabled, place the CA certificate file in the shared-folder\jp1ima\conf\user\cert.

   Also, enter the full path of the CA certificate in the immgr.tls_config.ca_file of the shared-folder\jp1ima\conf\jpc_imagentcommon.json.

6. Perform the required setup.

   7.3.7 Setting up the JP1/IM - Agent during new installation (for Windows), 1.21.2 Settings of JP1/IM - Agent to make the required configuration changes.

7. Reister the service for logical host in the cluster software.

   For JP1/IM - Agent service's registration to the clustered software, see 7.5 Registering into the cluster software during new installation and setup (for Windows).

8. Setup JP1/IM - Agent to determine if it has stopped servicing for one minute on setup of the clusters.

   If you upload the definition file to integrated operation viewer, restart of the service might occur after you deploy the definition file.

   Also, if the content of the uploaded definition file is invalid and the service fails to start, the definition file is restored and the service is started.

   As described above, you should setup the clusters to prevent them from detecting a temporary service outage because service might be temporarily stopped.

9. When using the data distribution function to multiple manager hosts, perform the following procedure before checking the operation.

   Execute New setting in 7.3.7(2)(a) Setting the data delivery function to multiple manager hosts (for Windows) (optional).

10. Check for problems in operation.

    • Start the service from the cluster software.

    • Causes a failover.

To Page Top