8.5 Registering into the cluster software during new installation and setup (for UNIX)
To apply cluster operation to JP1/IM - Manager during new installation and setup, you must register JP1/IM - Manager , JP1/Base and JP1/IM - Agent on the logical host into the cluster software, and then set them to be started and terminated by the cluster software.
Start services in the order of resources, JP1/Base, JP1/IM - Manager and JP1/IM - Agent.
The services covered by JP1/IM - Agent are: registered only the services to be used to the clusters.
-
jpc_node_exporter
-
jpc_blackbox_exporter
-
jpc_ya_cloudwatch_exporter
-
jpc_imagent
-
jpc_imagentproxy
-
jpc_imagentaction
-
jpc_alertmanager
-
jpc_prometheus_server
-
jpc_fluentd
After you register the clusters, you do the following:
-
Start
Start the service with the following command:
/opt/jp1ima/tools/jpc_service_start -s service-key -h logical-host
-
Stop
Stop the service with the following command:
/opt/jp1ima/tools/jpc_service_stop -s service-key -h logical-host
-
Forced stop
Stop the service forcibly with the following command:
/opt/jp1ima/tools/jpc_service_stop -s service-key -h logical-host -f
-
Operational monitoring
Check the status of the service with the following command:
systemctl is-active service-key_logical-host-name