6.8.1 Setup for linkage with JP1/AJS
- Organization of this subsection
(1) Setup for using system-monitoring objects for monitoring
To use a system-monitoring object of JP1/AJS, you must set JP1/AJS to issue JP1 events.
For details about the linkage setup, see the following manual:
-
Description of JP1/AJS
See the chapter that describes monitoring jobnets using JP1/IM in the JP1/Automatic Job Management System 3 Linkage Guide.
(2) Setup for generating a monitoring tree automatically
JP1/AJS supports automatic monitoring tree generation. To enable the linkage for automatic generation, set up the linkage program.
For details about the linkage setup, see the following manual:
-
Description of JP1/AJS
See the chapter that describes monitoring jobnets using JP1/IM in the JP1/Automatic Job Management System 3 Linkage Guide.
(a) For the JP1/AJS - Manager host
-
Setting up the linkage program for JP1/AJS
Execute the following command to enable collection of definition information from JP1/AJS when the monitoring tree is generated automatically:
ajs_adapter_setup -i (when enabling the linkage for automatic generation)
If the above setup is not completed, a JP1/AJS monitoring object is not created when an attempt is made to generate a monitoring tree automatically.
To release the linkage, execute the following command:
ajs_adapter_setup -u (when releasing the linkage for automatic generation)
(b) For the JP1/AJS - Agent host
There is no need to set up a linkage program at the JP1/AJS - Agent host. Once you complete the setup at the JP1/AJS - Manager, Central Scope extracts the job execution host and generates a monitoring tree automatically based on the jobnet definition that is collected during monitoring tree automatic generation.