6.7.5 Setting the memory-resident status change condition function
You can enable or disable the function for making status change conditions resident in memory.
In JP1/IM - Manager that has been installed as a new installation, this function is initially enabled. In JP1/IM - Manager that has been installed as an upgrade installation, the same setting that was specified in the previous version is initially retained. You should change the setting as appropriate to your operation.
To set the function for making status change conditions resident in memory:
-
Terminate JP1/IM - Manager.
-
Create a definition file for on memory mode of status change condition.
- About the settings in the file:
-
For details about the settings in the file, see Definition file for on memory mode of status change condition in Chapter 2. Definition Files in the JP1/Integrated Management 3 - Manager Command, Definition File and API Reference.
-
Execute the jbssetcnf command with the file created in step 2 specified as the argument.
When you execute the jbssetcnf command, the settings are applied to the JP1 common definition information.
For details about the jbssetcnf command, see the JP1/Base User's Guide.
-
Start JP1/IM - Manager.