8.2.3 Displaying the system hierarchy
Using IM Configuration Management, you can display the configuration definition information held in the IM Configuration Management database. The information appears on the IM Configuration page of the IM Configuration Management window.
The hosts defined in agent configuration and the hosts defined in a remote monitoring configuration by the integrated manager or base managers are displayed in the tree display area on the IM Configuration page. This is where you can check the system hierarchy. If the acquired configuration definition information (agent configuration) does not match with the configuration definition information held in the IM Configuration Management database, the system hierarchy appears grayed in the tree display area. In this case, perform the following to make the information of the different configuration definitions the same:
-
In the IM Configuration Management window, from the Operation menu, select Collect IM Configuration to acquire the configuration definition information.
-
In the Edit Agent Configuration window, from the Operation menu, select Apply Agent Configuration to apply the agent configuration.
|
For details about the displayed information, see 5.1.2 IM Configuration page in the JP1/Integrated Management 3 - Manager GUI Reference.
The following table describes the information displayed for individual components of the system hierarchy.
Component |
Information about lower-level hosts |
Basic information |
Product information |
Service operating information |
---|---|---|---|---|
Integrated manager |
Y |
Δ |
Δ |
Δ |
Base manager |
Y |
Δ |
Δ |
Δ |
Relay manager |
Y |
Δ |
Δ |
Δ |
Agent under a base manager |
N |
N |
N |
N |
Agent under the integrated manager or a relay manager |
N |
Y |
Δ |
Δ |
Remotely monitored host under a base manager |
N |
N |
N |
N |
Remotely monitored host under the integrated manager |
N |
Y |
Δ# |
Δ# |
- Legend:
-
Y: Can be displayed by default. Δ: Can be displayed. N: Cannot be displayed.
- #
-
This information can be displayed only when the host information is collected by JP1/Base.
The figure below shows the flow of processing when displaying the system hierarchy with IM Configuration Management.
|