6.5.3 Setting up execution monitoring
The functions for delay monitoring and status monitoring of automated actions are not enabled at installation and must be set up as required.
The table below describes the settings required to perform automated action delay monitoring and status monitoring. For details about the window, see the JP1/Integrated Management 3 - Manager GUI Reference. For details about the definition file, see the JP1/Integrated Management 3 - Manager Command, Definition File and API Reference.
Function |
Setting |
Where |
---|---|---|
Delay monitoring |
|
Action Parameter Detailed Definitions window or the automated action definition file |
|
Automatic action notification definition file |
|
|
||
Status monitoring |
|
Action Parameter Definitions window or automated action definition file |
|
Automatic action notification definition file |
|
|
Delay monitoring can be set for an individual action, whereas status monitoring is set for the whole system (JP1/IM - Manager). JP1 events are issued by default: When monitoring is enabled, a JP1 event is issued on detection of an error. Notification commands are not executed by default: To execute a notification command on detection of an error, you must edit the automatic action notification definition file.
If you disable both JP1 events and notification commands, detected errors will not be reported to the user even if you set Apply for Delay monitoring or Status monitoring. You must specify either means of notification to perform delay monitoring or status monitoring.