6.3 How to search for events in JP1/IM - View

To investigate a fault, in addition to the events listed in the event list, you must check the events to see if any events related to the fault have been issued. However, the event may have already been cleared from the event list during the failure investigation phase.

Let's search for events that have been cleared from the event list by specifying event conditions.

Keywords:

search events function, searching, investigation

Tip:

To display past events that are no longer displayed in the event list:

To display past events that are no longer displayed in the event list, use the event display start-time specification function. On the pages Monitor Events and Severe Events in the Event Console window, you can specify the display start-time for the event list by specifying a date and time or moving the slider. For details, see 6.6 Displaying an event by specifying an event display start-time in the Administration Guide.

Organization of this section

• 6.3.1 Using the search events function to search for events that match a specified condition

• 6.3.2 Verifying that events were found

To Page Top