2.4.1 Installing the prerequisite product (for Windows)
Before you start system monitoring with JP1/IM, you need to install JP1/Base on the hosts used as managers. If you also use JP1/Base as an agent, install JP1/Base on agent hosts as well.
- Organization of this subsection
(1) Installing JP1/Base (for Windows)
On the hosts that will be used as the manager and agents in the system monitored by JP1/IM, perform a new installation of JP1/Base.
Prerequisites
The following conditions must be satisfied:
-
JP1/Base supports the OS of the host on which the installation will be performed.
-
The user who performs the installation has Administrator permissions.
Procedure
-
Insert the JP1/Base distribution media into the drive.
Follow the instructions given by the installer after it starts. Specify the following items during installation:
-
User information
-
Installation folder
The default installation folder is as follows:
In an x86 environment:
system-drive:\Program Files\Hitachi\JP1Base
In an x64 environment:
system-drive:\Program Files (x86)\Hitachi\JP1Base
In an x64 environment, do not install JP1/Base under system-drive:\Program Files\. Problems might occur during operation if JP1/Base is in a Program Files folder that contains 64-bit modules. Do not install JP1/Base in the installation folder of any other product.
-
Automatic setup processing
If the Perform setup processing check box is selected, initial setup is automatically performed so that you can use the program immediately after installation is complete. When the window for entering the OS user name and password for the installation target host appears, enter the OS user name and password. This OS user name and password will be used for user mapping with the JP1 user (jp1admin) registered during initial setup. For details about user mapping, see 4.2.1 Configuring user mapping.
This manual assumes that initial settings were configured by automatic setup unless otherwise indicated.
-
-
If you are prompted to restart the system, restart Windows.