2.4.8 Setting up JP1/IM-Agent (for Windows)

Enables JP1/IM-Agent services (jpc_imagent) to be started from Process Management.

Prerequisites

The following conditions must be met:

• OS that executes the jpc_service command-user has Administrators privileges.

Operating procedure

1. Stop JP1/IM-Agent servicing by running the following command:

   jpc_service_stop -s all

2. Run the following command to enable servicing for JP1/IM-Agent:

   Agent pass\tools\jpc_service -on [servicename]

   The service name specifies the service name of JP1/IM-Agent to register.

3. Verify that JP1/IM-Agent serviceis registered by running the following command:

   services.msc

   You can check the services in management console. If the service exists, the service is valid.

4. Run the following command to start JP1/IM-Agent services:

   jpc_service_start -s all

Related topics

• 1.21 Setup for JP1/IM - Agent (For Windows) in the Configuration Guide

• 1. Commands for JP1/IM-Agent in the Command, Definition File and API Reference

To Page Top