E.2 HTTP Server settings
To specify HTTP Server settings for HACMP for AIX, follow the steps below.
-
Install HTTP Server onto the local disks of each node.
-
On the service node, create a HTTP Server configuration file, start script, stop script, and monitor method.
-
Distribute the configuration file, start script, stop script, and monitor method to the standby node, as needed.
-
In HACMP for AIX , define the application server used for HTTP Server.
-
In HACMP for AIX, define the application monitor used for HTTP Server.
-
Complete the definitions for HACMP for AIX, and sync the cluster definition in all nodes.
-
Start the cluster service.
Note the following points when configuring environments.
- Organization of this subsection
(1) Checking the configuration file syntax
Before starting cluster service, run /opt/hitachi/httpsd/sbin/httpsdctl configtest to make sure that the server settings are correct.
(2) Editing the configuration file
By running httpsdctl restart or httpsdctl graceful directly from the command line, you can change the settings of HTTP Server while it is in use on HACMP for AIX. Your changes need to be applied to the other nodes as well.
(3) Operation with CRL
In the standby node, you need to set the same type of CRL as the one being used for the service node.