4.11.10 Parameters used for setting up the Management Agent properties

The following table describes the parameters used for setting up the Management Agent properties. You can specify these parameters in the J2EE server and the batch server.

For details about the contents to be specified in param-value corresponding to 'Value of param-name', see 8.2.5 mngagent.actual-server-name.properties (Management Agent property file). When you reference the section, read the key as parameter. In the table below, Default value means the value that is assumed when the parameter is not specified. VR is the version of Application Server on which parameters are introduced or changed.

Table 4‒85: Parameters used for setting up the Management Agent properties
Value of param-name	Specifiable value	Default value	VR
`mngagent.connector.host`	The values that can be specified are as follows: Host name IPv4 address `@myhost` Note When specifying a host name or IPv4 address, specify the value of the `<host-name>` tag in the host definition. If you specify a different value, a warning message (KEOS24186-W) might be output, and the settings might not be what you intend. For host names, specify character strings of a maximum of 255 characters in length, consisting of alphanumeric characters, underscores (_), periods (.), and hyphens (-).	Value defined in vbroker.se.iiop_tp.host	07-50
`mngagent.connector.port`	Specify the value using an integer from 1 to 65535.	Value defined in vbroker.se.iiop_tp.scm.iiop_tp.listener.port	07-50
`mngagent.log.filesize`	Specify the value using an integer from 4096 to 2147483647.	65536	06-50 07-00 07-50

To Page Top