7.3.11 check
This subcommand checks whether Management Server and Administration Agent are active.
The following table lists and describes the arguments that can be specified for the check subcommand.
Argument |
Explanation |
Target specification |
|
---|---|---|---|
Logical server |
Host |
||
Mngsvr |
Checks whether or not Management Server is active. If a target is specified by the -t option, it is ignored. |
-- |
-- |
adminAgent |
Checks whether or not the Administration Agent is active at the host specified by the -t option. An error occurs when a value other than host is specified by the -k option, a value other than a host name is specified by the -t option, or the -t option is not specified. |
-- |
Y |
The check subcommand returns one of the following values:
- 0:
-
Active.
- 1:
-
Command execution error occurred#.
- 2:
-
Command syntax error occurred.
- 103:
-
Not active#.
#: If no response is returned from the Management Server before the operation check timeout time specified by the -w option elapses, the value that the subcommand returns differs depending on the specified argument as follows:
-
If the mngsvr argument is specified, the subcommand returns the end code 103.
-
If the adminAgent argument is specified, the subcommand returns the end code 1.