19.6 Starting and stopping the N-to-1 recovery system (In Windows)

This section describes the procedure for starting and stopping the system when you are using an N-to-1 recovery system.

When performing the operation using N-to-1 recovery system, you must specify beforehand the required environment settings beforehand, such as preparing the two hosts as the active node and spare node, and registering the script for monitoring, starting, and stopping the Administration Agent in which you run the cluster service. For details on how to specify the settings, see 19.4 Settings for the N-to-1 recovery system (In Windows).

Tip

When you use the N-to-1 recovery system, Management Server starts. In each Application-Server host, do not specify the settings for starting the Administration Agent together with the OS.

Reference note

When differentiating the nodes during operation, divide them into the 'executing node' and 'standby node'.

• Executing node

  This is the node containing N number of Application Servers for executing the business processing.

• Standby node

  This is the node containing a single recovery server.

Organization of this section

• 19.6.1 Starting the N-to-1 recovery system

• 19.6.2 Stopping the N-to-1 recovery system

To Page Top