8.6.2 Configuring load balancer connection information with the management unit
To configure load balancer connection information with the management unit, the system creator should set the connection information in the load balancer access setup property file (tierlb.properties) for each tier that is managed with the management unit.
Below is an example of configuring the connection information for the load balancer BIG-IP v9 for direct access through an API.
lb.type=BIG-IPv9 lb.host=192.168.2.14 lb.protocol=API lb.port=443 lb.user=user01 lb.password=user01pw lb.timeout=10
To use the load balancer connection information above, specify :unit: for the lb.use key in the property file (tier.properties) for each tier.