4.4 Setting and operating the batch application execution environment when using the scheduling functionality
This section describes how to set up and operate an execution environment for batch applications.
Even if you use the scheduling functionality, you use the Smart Composer functionality and server management commands to build an execution environment for batch applications. In this case, the same operation procedures and usable operation functionality of the batch application execution environment are used as when the scheduling functionality is not used.
For the procedure of building a batch application execution environment, see 2.2.3(1) Setting up the batch application execution environment. However, when using the scheduling functionality, you are required to set up an environment and build CTM and Smart Agent in addition to defining and setting up a batch server. You also use the Smart Composer functionality when building CTM and Smart Agent. For details, see 4.6 Setting up a system for executing batch applications in the uCosminexus Application Server System Setup and Operation Guide. For details on the operations that can be performed in a batch application execution environment and the operation procedures, see 2.2.3(2) Operating batch application execution environment.
You can integrate with JP1 and cluster software even in a system that uses the scheduling functionality. For details, see 2.2.3(3) Integrating with other programs.