C.2 Tuning parameters for optimizing the method of invoking the Enterprise Bean (methods other than the recommended procedures)
The location of tuning parameters used to optimize the method of invoking the Enterprise Bean are as follows:
- Organization of this subsection
(1) Using the local interface
You use the local interface defined in J2EE for creating an application.
The method is the same as specified for the recommended procedures.
(2) Using the local invocation functionality of remote interface
The following table describes the methods and locations to set up the tuning parameters for the local invocation functionality of the remote interface:
Setup item |
Method of setup |
Location of setup |
---|---|---|
Scope of local invocation optimization functionality |
Edit file |
ejbserver.rmi.localinvocation.scope key in usrconf.properties |
(3) Using the pass by reference functionality of remote interface
The following table describes the methods and locations to set up the tuning parameters for the pass by reference functionality of the remote interface:
Setup item |
Method of setup |
Location of setup |
---|---|---|
Usage of the pass by reference functionality of the remote interface (for each J2EE server) |
Edit file |
ejbserver.rmi.passbyreference key in usrconf.properties |
The usage of the pass by reference functionality of the remote interface (for each Enterprise Bean) is the same as specified in the recommended procedures.