5.3.4 Installation in Linux

This subsection describes the installation procedure in Linux.

Note that the names of files and directories on the installation media might be different from the names used in this subsection, depending on the hardware environment. Use the actual file and directory names displayed by the ls command.

1. Log on as the root user to the host where you want to install the programs, or use the su command to assume root user privileges.

2. Stop JP1/IT Desktop Management 2 - Agent when JP1/IT Desktop Management 2 - Agent is already installed on the host.

3. Load the distribution media.

4. Execute the mount command to mount the applicable device.

   For example, to mount the applicable device to the mount directory, execute the following command:

   mount -r -o mode=0544 device-special-file-name mount-directory-name

   Note that the command to execute varies depending on the environment.

5. Execute the following command to start Hitachi Program Product Installer:

   mount-directory-name/LINUX/setup mount-directory-name

   Hitachi Program Product Installer starts and the initial window appears.

6. From the initial window, enter I.

   A list of programs that can be installed is displayed.

7. Move the cursor to the JP1/IT Desktop Management 2 - Agent, select it by pressing the space key, and then enter I.

   JP1/IT Desktop Management 2 - Agent is installed.

8. Upon a successful installation, enter Q.

   This returns to the initial window of Hitachi Program Product Installer.

To Page Top