D.1 User account parameters

The following table lists and describes the parameters in the Account Management view.

User account parameters

Item	Description	Specifiable values	Default
User ID	Specify the user ID of the user account used to log in to JP1/ITDM2 - SDM (Smart Device Manager)	Character string of 8-50 half-width characters^#1	(Blank)
Password	Specify the password for the user ID.	Character string of 8-20 half-width characters^{#1 #2}	(Blank)
Re-enter Password	Enter the password again.	Character string of 8-20 half-width characters^{#1 #2}	(Blank)
User Name	Specify the user account name.	Character string of 20 or fewer full- or half-width characters	(Blank)
Email	Specify the email address of the user account user.	Email character string of 100 or fewer characters	(Blank)
Description	Enter a description of the user account.	Character string of 1,000 or fewer half-width characters	(Blank)
Permission	Specify whether to assign the system administrator permission to the user account.	Selected The system administrator permission is assigned. Not selected The system administrator permission is not assigned.	Not selected
Status	The user account can be unlocked if it has been locked.	Enabled Disabled	Disabled^#3

#1: You can use ASCII characters other than ASCII control characters.

#2: To change the password, specify a character string that is different from the current password.

#3: Displayed only when the user account has been locked.