KDEX4464-E

Failed to execute the command. The file path is invalid.

[Cause] The possible causes are as follows:

(1) The folder does not exist at the specified path, or the specified path is invalid.

(2) The length of the specified path is invalid.

(3) You do not have the permission to access the specified file.

(4) An I/O error occurred.

(5) The file format of the network control command setting file is invalid.

[Action] Cancel command execution.

[Workaround]

(1) Check whether the folder exists at the specified path and that the specified path is valid.

(2) Check the length of the specified path.

(3) Check whether you have the permission to access the specified file.

(4) Check whether a disk failure has occurred.

(5) Check the network control command setting file.

After performing these checks, re-execute the command.

Note:: This is the message concerning the network control command. For details about the location to which the messages are output, see "Output format of the network control command message file" in "jdnrnetctrl (controlling network access)" in the manual JP1/IT Desktop Management 2 Administration Guide.