4.7.1 Procedure for setting the configuration file used for linkage with JP1/IM

You can enable the functionality for linking JP1/IT Desktop Management 2 with JP1/IM by changing the configuration file settings.

To set a configuration file (jdn_manager_config.conf):

Add a setting to the configuration file.

The configuration file (jdn_manager_config.conf) is stored in the following location:

JP1/IT Desktop Management 2-installation-folder\mgr\conf

The following table describes the relevant definition in the configuration file.

Property	Description	Specifiable values	Default value
JP1IM_EventOption	Specify whether to link with JP1/IM. If linkage is specified, events occurring in the system are monitored regularly, and the events output to the JP1/IM event console are reported to JP1/Base. During regular monitoring, events for output to the JP1/IM event console occurring within 24 hours after ON for this property is detected are obtained.	`ON`: Link with JP1/IM. `OFF`: Do not link with JP1/IM.	`OFF`

Property

Description

Specifiable values

Default value

JP1IM_EventOption

Specify whether to link with JP1/IM. If linkage is specified, events occurring in the system are monitored regularly, and the events output to the JP1/IM event console are reported to JP1/Base.

During regular monitoring, events for output to the JP1/IM event console occurring within 24 hours after ON for this property is detected are obtained.

ON: Link with JP1/IM.
OFF: Do not link with JP1/IM.

OFF

The following is a setting example for the JP1/IM linkage configuration file:

# 
# configuration-file 
#
# server-customize-option
JP1IM_EventOption=ON

The settings in the configuration file are applied after the JP1/IT Desktop Management 2 service is restarted.

If you no longer want to link with JP1/IM, delete the line JP1IM_EventOption=ON that you added to the configuration file or change it to JP1IM_EventOption=OFF. Then, restart the JP1/IT Desktop Management 2 service.

To Page Top