1.7.8 Deploying agents to selected groups of computers on which agents have not yet been installed
You can deploy agents to selected groups of computers to be managed.
- Tip
-
During agent deployment, approximately 80 MB of data is sent to each computer.
To deploy agents to selected groups of computers:
-
In the Settings module, select Agent and then Windows Agent Deployment to display the Windows Agent Deployment view.
-
In Settings of the Components of the Agents to Be Deployed, click Edit.
If the agents to be deployed include a remote control agent, select the Include remote control agents check box in the displayed dialog box. If the agents to be deployed do not include a remote control agent, uncheck it.
-
Click OK to close the dialog box.
-
Select the computers to which you want to deploy agents.
-
Click the Deploy Agent button.
-
In the displayed dialog box, select an agent configuration you want to apply to computers.
In the Agent Configuration, displayed the agent configurations which are added in the Windows Agent Configurations and Create Agent Installers from the Agent in the Settings module. For details about adding agent configurations, see the description of managing agent configurations in the manual JP1/IT Desktop Management 2 Administration Guide.
-
Click the OK button.
Agents are deployed to selected computers. To view the agent deployment status, in the Settings module, select Agent and then Windows Agent Deployment to display the Windows Agent Deployment view.
- Tip
-
An agent is installed to the folder specified in the default agent configuration. If you have changed the installation folder, you need to specify the drive and the write-enabled folder. Note that the specified agent configuration is applied to computers after the installation is complete.