2.18.6 Agent configuration of a managed computer in a multi-server configuration
In a multi-server configuration, the agent configuration is assigned to managed computers from the server that manages the computers. Agent configuration cannot be assigned to a managed computer that is not managed by the local server.
Note that installation set that is used to install an agent can be applied only to the computers that are discovered directly under the management server on which the installation set is created.
- Tip
-
If you want to assign agent configuration to a managed computer that is not managed by the local server, use the operation window of the server that manages the computer.
Agent configuration items that can be set to the managed computers are the same among the primary management server, the management server in a single-server configuration, and management relay servers.
If you want to change the connection target of a managed computer, change the agent configurations from the management server that manages the computer. The managed computer whose connection target has been changed follows the new agent configuration.
- Tip
-
If you change the agent connection target from the setup of the managed computer, the connection target might revert to the original destination at the time when the agent configuration is applied from the management server which is the original connection target. In addition, if you change the agent connection target from the original target back to the new target, the assigned policy might temporarily revert to the default policy. To change the connection target from the setup of the managed computer, do not apply the agent configuration from the original connection target, until the managed computer appears in the device list as managed in the new destination target.