9.2 Reducing the maximum number of nodes displayed in a Network Overview map
The Network Overview map opens a map containing up to 250 of the most highly connected nodes in the Layer 3 network. If this map contains too many nodes, it might respond slowly when moving nodes or it might become too complex for practical viewing. You can change the maximum number of nodes displayed in the Network Overview map as shown in the following example.
Example: Suppose you want to reduce the maximum number of nodes displayed in the Network Overview map from 250 to 100.
To do this, follow these steps:
Edit the following file:
Windows: %NNM_PROPS%\nms-ui.properties
Linux: $NNM_PROPS/nms-ui.properties
Look for the following line:
#!com.hp.nnm.ui.networkOverviewMaxNodes=250
Specify the maximum value for the displayed node as follows:
com.hp.nnm.ui.networkOverviewMaxNodes=100
- Important
Make sure to remove the #! characters at the beginning of the line.
Save your changes.
Execute the following commands to restart NNMi:
ovstop ovstart