8.3.2 Configuring lifecycle transition actions

Note the following about configuring lifecycle transition actions:

• By default, NNMi runs actions at the following location:

  Windows:

  %NnmDataDir%shared\nnm\actions

  Linux:

  $NnmDataDir/shared/nnm/actions

  If an action is not at this location, specify the absolute path to the action in the Command field of the Lifecycle Transition Action form.

  Important

  Jython files must be placed in the actions directory.

• Each time you make a change to the action configuration, NNMi rereads the actions directory for Jython files and loads them into NNMi.

• Actions are enabled as a group for an incident type.

• For details about the NNMi information that you can pass to an action, see Valid Parameters for Configuring Incident Actions (SNMP Trap Incident) in NNMi Help.

To Page Top