26.3.4 Adding seeded discovery

1. Run the following command to check the accurate list of devices in the NNM database:

   ovtopodump > topology.out

   

2. From NNM, copy the topology.out (export) file and edit it. Alternatively, re-input the entries in a file for import into NNMi.

   For a new file, enter an IP address or host name on each line. Because NNMi automatically determines the subnet mask, you need not specify the subnet mask.

   10.2.32.201 # comment
   10.2.32.202 # comment
   lnt03.mycorp.net # comment
   lnt02.mycorp.net
   10.2.32.205

   Note

   Alternatively, you can also use the NNMi console to add a list of nodes.

3. Run the following command:

   nnmloadseeds.ovpl -f newSeedfile

   For details, see the nnmloadseeds.ovpl Reference Page.

   NNMi immediately begins discovering the devices associated with these seeds, and mounts the existing device profile (as well as node groups such as node groups for status monitoring). NNMi spiral discovery continues. For details about how to check the discovered seed results, see 3.3.3 Checking discovery progress.

To Page Top