21.6 Administering incident actions

You can configure actions to run automatically at any point in the incident lifecycle. For example, you might want to configure an action to occur when an incident of the type you are configuring is generated. For details, see Configure an Action for an Incident in NNMi Help.

To adjust action parameters, follow the steps shown in the following subsections.

Organization of this section

• 21.6.1 Setting the number of simultaneous actions

• 21.6.2 Setting the number of threads for Jython actions

• 21.6.3 Setting the action server name parameter

• 21.6.4 Changing the action server queue size

• 21.6.5 Incident actions log

To Page Top