15.11.4 Synchronizing regional manager discovery from a global manager

If you notice an information inconsistency between global1 and regional2, run the nnmnoderediscover.ovpl script from global1, which will cause global1 and regional2 to synchronize. This also results in regional2 updating global1 with any new discovery results. This example uses the network shown in the following figure.

Figure 15‒3: Global network management

Run the following command to synchronize nodes X, Y, and Z with global1:

nnmnoderediscover.ovpl -u username -p password -rm regional2

For details, see the nnmnoderediscover.ovpl Reference Page.

Note the following:

• NNMi automatically resynchronizes topology, state, and status following a manual resynchronization.

To Page Top