9.6 Configuring Auto-Collapse Thresholds for Loom and Wheel Diagrams
As NNMi administrator, you can configure the point at which Loom and Wheel diagrams initially auto-collapse
Nodes (hiding the interfaces) and Switches (hiding the ports) for better readability if the diagram is sufficiently complex. You can achieve this by adjusting the following properties in the nms-ui.properties file.
Property |
Description |
---|---|
com.hp.nnm.ui.wheelAutoCollapseThreshold |
Use this property to specify the number of labels required around the perimeter before the Wheel Diagram automatically collapses. |
com.hp.nnm.ui.loomAutoCollapseThreshold |
Use this property to specify the number of labels required throughout the diagram before the Loom Diagram automatically collapses. |
To configure auto-collapse thresholds, follow these steps:
-
Edit the following file:
-
Windows: %NNM_PROPS\nms-ui.properties
-
Linux: $NNM_PROPS/nms-ui.properties
-
-
Uncomment the required property, if required. See the comments in the nms-ui.properties file for details.
-
Update the threshold value as required and save your changes.
-
Reopen the diagram in NNMi console to implement your changes.