Hitachi

JP1 Version 12 JP1/Network Node Manager i Setup Guide


7.3.2 Configuring interface monitoring

State Poller analyzes interface group membership before node groups. For each of the interface groups you created, as well as any pre-existing ones you want to use, open the Monitoring Configuration form and the Interface Group Settings tab to create a custom set of instructions for how you want State Poller to handle that group. Your instructions will include the following:

You can configure different settings for each interface group. Remember that the State Poller evaluates the list in order from the lowest ordering number to the highest ordering number.

Tip

Double-check your order numbers, keeping in mind that an object that qualifies for multiple groups has settings applied from the group with the lowest order number.