1.1 General procedure for setting up JP1 network management products
To set up JP1 network management products, the Monitoring Manager and the Monitoring Agent need to be set up. The procedure for setting up the Monitoring Manager or the Monitoring Agent is different between Windows and Linux.
The following table shows the general procedure for setting up the Monitoring Manager.
Task overview |
Step |
Task details |
Reference |
|
---|---|---|---|---|
Windows |
Linux |
|||
Preparation before installation |
1 |
Check the server environment. |
1.2.1 |
|
2 |
Check the prerequisites of the Monitoring Manager. |
1.2.2 |
1.2.3 |
|
Setting up the Monitoring Manager |
3 |
Install NNMi. |
1.3.1 |
1.4.1 |
4 |
Install SSO. |
1.3.2 |
1.4.2 |
|
5 |
Install NEM. |
1.3.3 |
-- |
|
6 |
Set up NNMi. |
1.3.4 |
1.4.3 |
|
7 |
Set up SSO. |
1.3.5 |
1.4.4 |
The table below shows the general procedure for setting up the Monitoring Agent. To set up the Monitoring Agent, repeat the following procedure according to the number of Monitoring Agents at each site:
Task overview |
Step |
Task details |
Reference |
|
---|---|---|---|---|
Windows |
Linux |
|||
Preparation before installation |
1 |
Check the server environment. |
1.2.1 |
|
Setting up the Monitoring Agent |
2 |
Check the prerequisites of the Monitoring Agent. |
-- |
1.6.1 |
3 |
Install ESA. |
1.5.1 |
1.6.2 |
|
4 |
Install SSO-AP. |
1.5.2 |
1.6.3 |
|
5 |
Set up ESA. |
1.5.3 |
1.6.4 |
|
6 |
Set up SSO-AP. |
-- |
1.6.5 |
|
7 |
Restart the Monitoring Agent. |
-- |
1.6.6 |
- Tip
Before setting up the Monitoring Agent, ask the system administrator of each site beforehand. Setup of the Monitoring Agent needs to be complete before you set up JP1 network management products.