1.6.6 Restarting the Monitoring Agent (for Linux)
After the setup of ESA is complete on the Monitoring Agent for Linux, restart ESA and SSO - AP to apply the settings.
Procedure
Execute the apmstop command of SSO - AP to stop SSO - AP.
Execute the snmpstart command of ESA to start ESA.
Execute the apmstart command of SSO - AP to start SSO - AP.
Execute the snmpcheck command of ESA to check the ESA status.
If all statuses are in the running status, there is no problem.
Execute the apmcheck command of SSO - AP to check the SSO - AP status.
If all statuses are in the running status, there is no problem.
Next steps
Next, specify settings for monitoring the network.