1.3.4 Setting up NNMi (for Windows)

If the Monitoring Manager is to run on Windows, stop the NNMi service, and then set up the system account. To register other members, first log in to the NNMi console, and then register users.

Before you begin

If the command prompt was opened before the installation and remains open, close it, and then open it again.

Procedure

In the command prompt, execute ovstop -c to stop the NNMi service.
The NNMi service stops. Immediately after the installation, the NNMi service is stopped.
Execute nnmchangesyspw.ovpl to set the password.
Enter y, and then specify the password by following the message.
Execute ovstart -c to start NNMi.
Execute ovstatus -c to check the NNMi status.
If all statuses are in the running status, there is no problem.

Next steps

Next, set up SSO.