2.9.1 Notes on operating PFM - RM for Virtual Machine
-
Any virtualization software products supported by PFM - RM for Virtual Machine need to be installed, set up, and started before you start PFM - RM for Virtual Machine.
-
When you perform a new installation of this product, the first icon displayed might be replaced immediately by another icon. This problem concerns only what icon is displayed. Product operation is not affected.
-
For notes on executing the jpcspm start command or the jpcspm stop command for PFM - RM for Virtual Machine, see the chapter that describes commands in the manual JP1/Performance Management Reference.
-
For notes on executing the jpctool service list command for the Remote Monitor Collector service or Remote Monitor Store service, see the chapter that describes commands in the manual JP1/Performance Management Reference.
-
PFM - RM for Virtual Machine does not support configurations where the same monitoring target is monitored from more than one instance of the product.
-
When specifying an execution module in the Windows WOW64 system directory (SysWOW64) for an alarm action definition, see the chapter that notes on creating alarms in the manual JP1/Performance Management User's Guide.
-
To use PFM - RM for Virtual Machine in an IPv6 environment, the operating environment must be an IPv4/IPv6 dual stack environment. This is because the IPv4 stack is used to communicate with JP1/SLM - Manager.