E. List of Port Numbers
This appendix describes the port numbers used by PFM - RM for Platform.
For details about the port numbers for PFM - Manager and PFM - Base, and the firewall passage directions, see the appendix in the manual JP1/Performance Management Reference.
You can change port numbers as appropriate to your system environment. For details about how to change port numbers, see the chapter that describes installation and setup in the JP1/Performance Management Planning and Configuration Guide. The TCP/IP protocol is used.
- Notes:
-
-
Performance Management supports static NAT (Basic NAT), which performs one-to-one address conversion. Note, however, that PFM - RM for Platform does not support static NAT (Basic NAT) because WMI cannot resolve IP addresses based on NAT when the monitored host is running Windows.
It does not support dynamic NAT or NAPT (IP Masquerade, NAT+), which include a port conversion function.
-
When PFM - RM for Platform is used in an environment in which the Windows firewall is enabled, you must register the port number used by PFM - RM for Platform to the exception list. For details about settings for the Windows firewall, see E.3 Settings for the Windows firewall.
-
- Organization of this section