KAVE00547-W
An attempt to update the alarm application state failed. (service=service-ID)
An attempt to update the alarm application status failed.
The service ID of the agent or Action Handler that failed to be updated is displayed in place of service-ID.
- (S)
-
Continues processing.
- (O)
-
For the cause, check the error message that was output to the common message log. After eliminating the cause, take the following action according to the application status of the service indicated in service-ID.
- If the application status is Failed or Uncertain
-
Execute the command jpctool config alarmsync
- If the application status is not Failed or Uncertain
-
Restart the service indicated in service-ID