13.5.5 Synchronizing monitoring settings after backing up and restoring PFM - Manager or JP1/SLM

If you back up and restore JP1/SLM or PFM - Manager, you must manually synchronize their respective monitoring settings.

To synchronize monitoring settings:

1. Start PFM - Manager.

2. Start JP1/SLM and log on.

3. Update the configuration information in the JP1/SLM Configuration information settings window.

   Synchronize the configuration information and monitoring items between PFM - Manager and JP1/SLM.

4. This step is required only when restoring JP1/SLM. Check the monitoring settings and whether monitoring is ON or OFF in the JP1/SLM Monitor settings window.

   Check the following:

   • Monitoring (ON or OFF) of monitoring items

     The node color indicates ON or OFF. Make sure that:

     Nodes that are supposed to be ON are not set to OFF.

     Nodes that are supposed to be OFF are not set to ON.

   • Monitoring settings for monitoring items:

     Make sure that the threshold values and predictive error detection settings for ON nodes are correct.

5. In the Start/Stop monitor window, synchronize the monitored status (Start or Stop) and monitoring settings with PFM - Manager.

   Set as follows according to whether each service is being monitored:

   • Service being monitored

     Start service monitoring and update PFM - Manager with the latest monitoring settings in JP1/SLM.

   • Service not being monitored

     Stop service monitoring and stop monitoring by PFM - Manager.

For details on the JP1/SLM operations, see the manual Job Management Partner 1/Service Level Management.

To Page Top