Hitachi

JP1 Version 12 JP1/Performance Management User's Guide


10.4.1 Before installation and setup

Organization of this subsection

(1) Prerequisite conditions

(a) Cluster system

Make sure that the following conditions are satisfied:

  • The cluster system is controlled by cluster software.

  • Settings are made so that the starting and stopping of Performance Management used on a logical host are controlled by cluster software.

(b) Shared disk

Make sure that the following conditions are satisfied:

  • Each logical host has a shared disk, and the disk can be taken over from the executing node by the standby node.

  • Shared disks are physically connected to each node via Fibre Channel or SCSI. Configurations in which the shared disk is a network drive or disk replicated over a network is used are not supported.

  • When a failover occurs, if some processes are still using the shared disks, make sure it is still possible to force shared disks offline via cluster software or by other means and perform a failover.

  • If multiple Performance Management programs are executed on a single logical host, make sure the directory names for the shared disks are the same. For Store databases, make sure the storage destination can be changed to allow storage in a different directory on the same shared disk.

(c) Logical host name and logical IP address

Make sure that the following conditions are satisfied:

  • There is a logical host name and corresponding logical IP address for each logical host, and switching from the executing node to the standby node can be performed.

  • The logical host and logical IP address are set in the hosts file and on the name server.

  • If using a DNS, a logical host name is specified without a domain name, instead of by using a FQDN.

  • Each physical host name and logical host name is unique within the system.

    Important

    Notes regarding logical host names:

    • Do not use a physical host name (a host name displayed using the uname -n command) for a logical host name. Otherwise, normal communication processing might be prevented.

    • Logical host names must consist of from 1 to 32 bytes alphanumeric characters.

    • localhost, an IP address, or a string that begins with a hyphen (-) cannot be used for a logical host name.

(d) Other prerequisite conditions

Make sure that the following conditions are satisfied:

  • Kernel parameters have been optimized.

(2) Checking the setup environment

In addition to the environment information normally required to set up Performance Management, the following information is required to set up Performance Management used on a logical host.

Table 10‒7: Information required to set up PFM - Manager to be used on a logical host (in UNIX)

Item

Example

Logical host name

jp1-ha1

Logical IP address

172.16.92.100

Shared disk

/usr/jp1

If multiple instances of Performance Management use a single logical host, each instance uses the directory of the same shared disk.

(3) Notes about upgrading when a logical host is used

To upgrade PFM - Manager on a logical host, you must place a shared disk online on either an executing or a standby node.

However, there is no need to place a shared disk online to upgrade PFM - Web Console in a cluster environment.