5.7.3 Setting the display conditions for a report

You can set the display conditions for a report in the following two ways:

Set the display conditions when defining the report

Set the report display conditions when defining the report by using the window of PFM - Web Console or by using the jpcrdef create command.

The display conditions set when defining a report are permanently registered in the PFM - Web Console system. This will not be affected with operations such as opening or closing of the window, startup, and exit from the system. These conditions are permanently registered until deleted from the PFM - Web Console system in the window of PFM - Web Console or through the jpcrdef delete command.
Set the display conditions when or while displaying the report

Set the report display conditions in the Show Options tab of the View Report window when you first display the report or while it is displayed.

The report display conditions set in the Show Options tab are restricted to the window where the display conditions are set or changed, and are not permanent. For example, even if the same report is displayed in a separate window at the same time, the contents set in the Show Options tab are applied only to the window where the operation is carried out. In addition, display conditions that are set or changed in one window are retained until the window closes.

Note that you can set the report display conditions by using the function for editing the displayed report. For details on the function for editing the displayed report, see 5.3.10 Editing a report.

Note:: When a registration report enabled for Specify when displayed is executed from the bookmark hierarchy, data is obtained with the display settings registered for the bookmark. The obtained data shown above is displayed when Cancel is clicked in the ShowOptions window.

Organization of this subsection

(1) Setting display conditions when first displaying a report
(2) Setting display conditions while displaying a report

(1) Setting display conditions when first displaying a report

To set display conditions when you display a report:

Display the View Report window for the report whose display conditions you want to set.

The View Report window appears with the Display report settings page displayed.

For details on how to display the View Report window, see 5.7.1 Displaying reports.
Set the display conditions.
Click the OK button.

The View Report window appears subject to the display conditions you applied in step 2.

(a) When setting the collection interval and retrieval interval of data

Report definition in the PFM - Web Console window:: Select Specify when displayed in the New Report > Indication Settings window.
Report definition in command input:: Specify TRUE for the specify-when-displayed attribute of the indication-settings parameter. Alternatively, omit the child element date-range of the indication-settings parameter.

(b) When setting the data filter conditions

Report definition in the PFM - Web Console window:

Select Specify when displayed in the New Report > Filter window.

Report definition in command input:

Specify TRUE for the Specify-when-displayed attribute of the record - condition-expression - expression parameter.

The hyphen (-) indicates a layer when defining the report. record - condition-expression means to specify condition-expression for a child element of the record parameter.

(c) When setting the collection interval and retrieval interval of data and filter conditions

Report definition in the PFM - Web Console window:

Select Specify when displayed in the New Report > Indication settings window.

Also, select Specify when displayed in the New Report > Filter window.

Report definition in command input:

Specify TRUE for the specify-when-displayed attribute of indication-settings parameter. Alternatively, omit the child element date-range of indication-settings parameter.

Specify TRUE for the Specify-when-displayed attribute of the record - condition-expression - expression parameter.

The hyphen (-) indicates a layer when defining the report. record - condition-expression means to specify condition-expression for a child element of the record parameter.

To Page Top

(2) Setting display conditions while displaying a report

Use this procedure if you want to change display conditions each time you display the report.

Display the View Report window to set display conditions.

For details on how to display the View Report window, see 5.7.1 Displaying reports.
Click the Show Options tab in the View Report window.
Set the display conditions on the Display report settings page.
Click the OK button.

The View Report window affected by the display conditions of step 3 is displayed.

To Page Top