2.3 Tasks involved in user account setup

This section describes the tasks involved in setting up user accounts for each authentication mode.

Table 2‒3: Tasks required to set up user accounts (PFM authentication mode)
Operation target	User permission	Description of task	Overview
Entire system	Management user	2.5.1 Creating a Performance Management user account	Create a user account with Management user selected as the user permission.
Entire system	Ordinary user	2.5.1 Creating a Performance Management user account	Create a user account with Ordinary user selected as the user permission.
Business group^#	Ordinary user	2.7.2 Defining business groups in Performance Management	Create a business group.
Business group^#	Ordinary user	2.5.1 Creating a Performance Management user account	Create a user account as follows: Select Business group ordinary user as the permission Select the business groups to associate with the user account

#: Access control based on business groups must be set up before you perform these tasks. For details, see 2.7.1 Setting up access control based on business groups.

The table below describes the tasks required to set up a user account that uses JP1 authentication mode. You must set the authentication mode in Performance Management before you set up user accounts that use JP1 authentication mode. For details, see 2.4 Setting the user account authentication mode.

Table 2‒4: Tasks required to set up user accounts (JP1 authentication mode)
Operation target	User permission	Description of required tasks	Overview
Entire system	Management user	2.6 Setting operating permissions for JP1 users	Set the JP1 user operating permissions to allow users to have administrator user permission for Performance Management.
Entire system	Ordinary user	2.6 Setting operating permissions for JP1 users	Set the JP1 user operating permissions to allow the JP1 user to have ordinary user permission for Performance Management.
Business group (Performance Management)^{#1, #2}	Ordinary user	2.7.2 Defining business groups in Performance Management	Create business groups.
Business group (Performance Management)^{#1, #2}	Ordinary user	2.6 Setting operating permissions for JP1 users	Set the operating permissions for the JP1 user as follows: Specify the JP1 resource groups to associate with the business group Select the JP1 permission level to assign ordinary user permission to Performance Management users
Business group (JP1/IM)^{#1, #3}	Ordinary user	2.7.3 Using business groups defined in JP1/IM.	Import the business groups defined in JP1/IM into Performance Management. Also, add a JP1 permission level that gives JP1 users ordinary user permission in Performance Management.

#1: Access control based on business groups must be set up before you perform these tasks. For details, see 2.7.1 Setting up access control based on business groups.
#2: A user associated with a business group defined in Performance Management.
#3: A user associated with a business group defined in JP1/IM.

To Page Top