KAVB3107-E
Cannot set configuration in the host. host-name
A host was found for which configuration information could not be set during confirmation of the configuration definition.
- (S)
-
Causes an error in the jbsrt_distrib command.
- (O)
-
Make sure of the following for the host where the error occurred:
-
JP1/Base is running. (You can check this by using the jbs_spmd_status command.)
-
The configuration management port (default: 20237/tcp) is running. (You can check this by using the netstat command.)
-
The configuration management port (default: 20237/tcp) is not filtered by a firewall.
-
The name of the host that caused the error can be resolved by its higher-level host. (You can check this by using the jp1ping command.)
-
The correct IP address you intended is obtained by name resolution.
-
The host that caused the error was not defined as the highest-level host. (You can check this by using the jbsrt_get command.) If this host is defined as the highest-level host in any configuration information, use the jbsrt_del command to delete that configuration information.
-
There is sufficient memory.
-
You have read and write permissions for the conf/route/ directory.
If you did not find any problems, perform the following procedure to check the host on which the error occurred:
-
Execute the jbsrt_get command.
-
Check whether one of the following occurred:
- The KAVB3162-E message appeared.
- The jbsrt_get command terminated abnormally.
- The local host name appeared in Upper host or Lower host.
- A host name other than that of the local host appeared in Local host.
- The host name is garbled.
-
If any of the above problems occurred, use the following procedure for recovery:
1. Use the jbsrt_del command to delete the configuration definition.
2. From the manager host, use the jbsrt_distrib command to re-distribute the configuration definition.
-