Hitachi

JP1 Version 12 JP1/Base Messages


KAVB2064-E

Error in writing execution results to Command execution log.

An attempt to write the command execution log file has failed.

(S)

Does not save the command execution results in the command execution log file.

(O)

Check the following. If the problem cannot be corrected, use the data collection tool to collect data, and then contact the system administrator.

  • Make sure that there are sufficient system resources.

  • Make sure that the operating system is running normally.

  • Make sure that the disk to which the command execution log file is output has sufficient free space.

  • Make sure that the output destination of the command execution log file has appropriate permissions.

  • The command execution log file might be corrupted. In this case, execute either of the following commands to recover the execution log file:

    For details on how to check the status of the command execution log file and how to recover the file, see the chapter about troubleshooting in the JP1/Integrated Management 2- Manager Administration Guide.

    If the command execution log file is in normal status, execute the data collection tool of JP1/IM, and then contact the system administrator.