Hitachi

JP1 Version 12 JP1/Base Messages


KAVA0458-I

Restart JP1/Base to apply the changes.

The changes have not been applied yet. To apply the changes, JP1/Base must be restarted.

(O)

Restart JP1/Base and all products that require JP1/Base.

If this message is output when the file is imported to JP1/Base on a physical host, you must also restart JP1/Base on the logical host on which either +PhysicalMerge is enabled or the jp1hosts2 definition file has not been imported. In this case, you must also restart all products that require that JP1/Base.

Note that this message is always output when the jp1hosts2 information is set for the first time. If this message is output upon the addition of hosts, there is no need to restart JP1/Base.