Hitachi

JP1 Version 12 JP1/Base User's Guide


8.3 User management setup (in UNIX)

If you use automatic setup to install JP1/Base, JP1/Base is installed with the default settings. For details on the default settings that apply to an automatic setup, see 3.3.1 Installing JP1/Base.

The setup method differs depending on whether the host is to be used as an authentication server.

If you use the secondary authentication server, setting information for both the primary authentication server and the secondary authentication server must be the same. The following figure shows the setup procedure required on each host and the corresponding sections in this manual.

Figure 8‒13: User management setup procedure (in UNIX)

[Figure]

Organization of this section