6.10.2 Resetting JP1/Base to single network use (with jp1hosts2 information)

1. Delete jp1hosts2 information.

   If you registered jp1hosts2 information, delete it by executing the jbshosts2import command as follows:

   jbshosts2import -d [-h logical-host-name]

2. Apply the communication protocol settings file to the common definition information.

   Execute the jbssetcnf command to apply the file contents to the common definition information.

   For a physical host, execute the jbssetcnf command as follows.

   • If a logical host environment is present on the same host:

     jbssetcnf physical_ipany.conf

     jbssetcnf physical_recovery_0651.conf

   • In an environment with a physical host only:

     jbssetcnf physical_anyany.conf

   For logical hosts, open the logical_ipany.conf and logical_recovery_0651.conf by using a text editor or similar, look for [LOGICALHOSTNAME\JP1BASE], and then replace LOGICAHOSTNAME with the logical host name you specified when setting up the cluster system. Then, execute the jbssetcnf command as follows:

   jbssetcnf logical_ipany.conf
   jbssetcnf logical_recovery_0651.conf

3. Restart JP1/Base.

   Also restart products for which JP1/Base is a prerequisite and programs which have dependency relationships with JP1/Base.

To Page Top